News

It has been debugged before leaving the factory, and everything is normal before leaving the factory. However, due to the transportation process, the bolts and other looseness may be caused. Please check the equipment before use. Before use, the machine should be placed on a flat ground before use.

How much do you know about the installation and commissioning of the fries cutting machine? Follow the editor of Wholesale Hydraulic cutting fries equipment to have a simple understanding!
1. It has been debugged before leaving the factory, and everything is normal before leaving the factory. However, due to the transportation process, the bolts and other looseness may be caused. Please check the equipment before use. Before use, the machine should be placed on a flat ground before use.
2. If it is a three-phase 380V power supply, after turning on the power, start the test machine first to see if the centrifugal hopper is running in the correct direction. The clockwise rotation is the correct direction. Do not reverse it. Reversing will damage the tool! ! For personal safety, please ground the enclosure of the device, and the grounding resistance shall not be greater than 4 ohms.
3. If there is an abnormal sound when the test machine is started first, stop it immediately, and then check whether there is any foreign matter in the hopper, if it has just been cleaned up, it can be produced.
In summary, the editor of Wholesale Hydraulic cutting fries equipment tells: a brief introduction to the knowledge about the installation and debugging methods of the fries cutting machine.