News

With the development of economy, the application range of Dryer has become more and more extensive. When processing materials, they generally have a long running time and a large amount of processing. This directly leads to more or less appearance of Dryer during use and operation. Large and small problems affect the normal use of the equipment. Oil leakage is a relatively common type of Dryer operation and problems. So, how can we avoid and solve this problem? The editor of Fruit and Vegetable electroporation has some suggestions here:
1. During operation, due to the failure to clean up in time, some oil holes on the oil pipeline are easily blocked by the slag of the material, which causes the oil pressure inside the oil pipe to increase, and the amount of oil injected by the oil ring increases, which is easy to splash into the equipment. The external causes the internal and external oil leakage of the whole set of Dryer. Therefore, in this case, the equipment needs to be cleaned and cleaned in time to dredge the oil injection hole.

2. When injecting fuel, the fuel injection valve is enlarged and the fuel injection volume is large. Under normal circumstances, the oil will fall from the fuel injection hole to some of the crankshafts inside the equipment. At the same time, the operation of the equipment will cause oil splash. , Resulting in the drying quality and difficulty of operation of the equipment. In response to this situation, professional technicians are required to fine-tune the fuel injection link of the equipment to ensure that the equipment is normally lubricated without causing oil shortage and oil temperature to affect the equipment. There are also some factors because when the Dryer is lubricated, the oil is thrown out of the oil leakage ring, which causes the oil leakage of the entire equipment. To prevent this from happening, Dryer sets a rubber plate between the oil ring and the oil hole. Isolated the splash of oil incident. It is also possible to increase the overall area of the oil injection hole by replacing the parts of the entire equipment, so as to ensure that the lubrication of the oil shaft will not cause blockage and oil leakage of the equipment.
The above are some suggestions from the editor of Fruit and Vegetable electroporation introducing Dryer oil spills.