Fruit and vegetable electroporation tells: What are the reasons for Dryer blockage?
When we use Dryer, clogging may occur. In order to extend the service life of the product, we need to understand what causes the clogging.
When we use Dryer, clogging may occur. In order to extend the service life of the product, we need to understand what causes the clogging. Let’s follow the editor of Fruit and vegetable electroporation to have a simple understanding!
1. The viscosity of the material is too large. If the viscosity of the material to be dried is too large, it will easily adhere to the inner wall of the drum after it enters the interior of the Dryer. If the cleaning device in the drum cannot remove the adhesive in time, the longer the time, the longer the time. The more products, the more barrier materials are formed. Therefore, for high-viscosity materials, we need to clean the interior accordingly to facilitate the timely removal of adhered materials.
2. The moisture content of the material is too high. When the moisture content of the material is too high, it is easy to cause agglomeration and agglomeration during the drying process, which will affect the feeding efficiency and even cause Dryer to block the material. In this case, we need to strictly control the water supply to prevent clogging.
3. Insufficient heat in Dryer. The dehydration treatment of materials is mainly carried out under the effect of heat transfer. If the heat in the drum is insufficient, the moisture in the high-humidity material cannot be quickly removed, thereby prolonging the retention time of the material in the drum, so it is easy to block the material, so ensuring sufficient heat and stable temperature is the key to prevent clogging of the material One of the factors.
The above is an introduction by the editor of Fruit and vegetable electroporation: You can learn more about the causes of blockage caused by Dryer.