News

After each use, the hopper chamber and blades should be cleaned. Especially after cutting acid and alkaline substances, they should be wiped dry with a damp cloth.

Do you know how to use the fries cutting machine and the knowledge of cleaning and maintenance? Follow the editor of Hydraulic cutting fries machine to have a simple understanding!
1. Installation and commissioning of equipment
1. This machine has been debugged before it leaves the factory, and everything is normal before it leaves the factory. However, due to the transportation process, the bolts and other looseness may be caused. Please check the equipment before use. Before use, the machine should be placed on a flat ground before use.
2. If the machine is a three-phase 380V power supply, after turning on the power, start the test machine first to see if the centrifugal hopper is running in the correct direction. The clockwise rotation is the correct direction, and it must not be reversed. Reversal will damage it. Tool!
3. If there is an abnormal sound when the test machine is started first, stop it immediately, and then check whether there is any foreign matter in the hopper, if it has just been cleaned up, it can be produced.
2. Use and operation of equipment
1. The materials need to be cleaned before processing. They must not contain sand, hard shell and leather, otherwise the blade will be damaged, the life of the blade will be shortened, and there will be debris after muddy, which will affect the quality of the food.
2. After everything is normal, you can put the material into the hopper. If the material is too long, cut the material first before putting it in.
3. Blade adjustment method: This machine can change the cutting size by adjusting the blade down by 1-2mm.
The adjustment method is as follows: open the long discharge nozzle, first adjust the large blade (thickness) adjustment: first use a wrench to loosen the four large nuts holding the large blade, and push this part up slightly by 1-2mm, Then lock the nut to fix the large blade. Small blade adjustment method: There are plastic spacers between the small blades. Generally, a spacer is 1mm or 2mm. Reduce the plastic spacer between the blades by 1 or 2 pieces, and then fix it with a nut.
Three, cleaning and maintenance
After each use, the hopper chamber and blades should be cleaned. Especially after cutting acid and alkaline substances, they should be wiped dry with a damp cloth. When cleaning the machine, be careful not to turn on the wet power switch and motor to avoid short circuit and other situations. When sharpening the knife, the blade can be removed from the machine and grind it with a whetstone. During the grinding process, be careful not to overheat the blade to prevent annealing.
The above is the editor of Hydraulic cutting fries machine telling some related knowledge, you can learn more about it.