During the application of Cheapest Dryer from China manufacturer, if there is an oil leakage problem, we must deal with it in a timely manner. Generally, this situation is due to the long running time and large processing volume when we are processing materials. Cause a series of problems, thereby affecting the normal use of the equipment. Oil leakage is a relatively common type of operation and problems of Cheapest Dryer from China manufacturer. So, how can we avoid and solve this problem? Let's follow the editor of Cheapest Osmotic dryer products to have a simple understanding!

1. During operation, due to the failure to clean up in time, it is easy to cause some oil holes on the oil pipeline to be blocked by the slag of the material, which causes the oil pressure inside the oil pipe to increase, and the amount of oil injected by the oil ring increases, which is easy to splash. The outside of the equipment causes the internal and external oil leakage of the whole set of Cheapest Dryer from China manufacturer. Therefore, in this case, the equipment needs to be cleaned and cleaned in time to clear the oil injection holes.
2. When injecting fuel, the fuel injection valve is enlarged and the fuel injection volume is large. Under normal circumstances, the oil will fall from the fuel injection hole to some of the crankshafts inside the equipment. At the same time, the operation of the equipment will cause oil splash. , Resulting in the drying quality and operating difficulty of the equipment. In response to this situation, professional technicians are required to fine-tune the fuel injection link of the equipment to ensure that the equipment is normally lubricated without causing oil shortage and oil temperature to affect the equipment. There are also some factors because when lubricating the Cheapest Dryer from China manufacturer, the oil is thrown out of the oil leakage ring and the oil leakage of the entire equipment is caused. In order to prevent this kind of situation, the Cheapest Dryer from China manufacturer is in the oil ring and A rubber plate is set between the oil holes to completely isolate the splashing of oil incidents. It is also possible to increase the overall area of ​​the oil injection hole by replacing the parts of the entire equipment, so as to ensure that the lubrication of the oil shaft will not cause blockage and oil leakage of the equipment.
The above is the editor of Cheapest Osmotic dryer products introducing the solutions for oil leakage during the use of Cheapest Dryer from China manufacturer. You can learn more about it.